Larry Edgerton
05-12-2016, 7:19 AM
I am running a 9 hp motor on a Unitronix and started blowing the one amp fast burn fuses on the control panel. Pain in the tush and they are about $15 each, and not available locally. This just cropped up recently, but I have blown 5 now in the last month. The shaper has two motors, but I never run two at the same time.
I am running it off of a 25hp rotary converter, and I suspect that is where it is coming from, but I am no expert, and that is an understatement. I am going to be switching to a Phase Perfect when I can, but for now this is what I have.
Anyway...... any ideas what can cause this problem? Another thing that is strange, it will work all day long, but all of the fuses have been blown when I come in in the morning. shut it down at night, come in to go to work, and nothing. Not every day, and never in the middle of the day.
Larry
I am running it off of a 25hp rotary converter, and I suspect that is where it is coming from, but I am no expert, and that is an understatement. I am going to be switching to a Phase Perfect when I can, but for now this is what I have.
Anyway...... any ideas what can cause this problem? Another thing that is strange, it will work all day long, but all of the fuses have been blown when I come in in the morning. shut it down at night, come in to go to work, and nothing. Not every day, and never in the middle of the day.
Larry