Question about Millers Falls brace

[Kees Heiden]

This weekend I purchased an 12" Millers Falls brace. It seems to be in prime condition, but maybe with one exception. I am not quite sure if the frame has been bend out of line. Is this the normal shape of these things, or has it losts it's original shape?

337211

[Rob Paul]

It's bent.
Just bend it back to get the chuck and head in line again.
(or use it as-is)

[Kees Heiden]

Thanks Rob. Then I'll get me some leverage to give it a tweak.

[Mike Holbrook]

The other physical factor that will make the brace not work properly is a loose head that "wallies" around keeping the brace from drilling straight holes. It may be possible to replace ball bearings, lubricate the head, tighten screws...so that it works better.

[Kees Heiden]

Luckilly the rest of the brace is in perfect shape. I didn't have the time yet to get around to bend it back in shape, probably a job for the weekend.

[Kees Heiden]

Last night I pulled it straight again. It was utterly simple, just clamp it in the vise and pull on the other end. The head is now inline with the bit again.