Plans for fold down outfeed table for cabinet saw

[chris ormsby]

I am looking for plans for a fold down outfeed table to bolt up to my grizley cabinet saw. The only specific need I have is that in the up position, it is braced to the back of the saw,. Legs going to the floor would be a huge hassle being that my concrete floor leaves a lot to be desired at best. Thanks in advance!

[mark mcfarlane]

Not all 'plans', but googling "table saw outfeed" and looking at the "Images" results leads you to many pictures, including this step-by-step from Rockler (http://www.rockler.com/how-to/building-outfeed-table-mount-table-stand-support/)

[Brian Tymchak]

There have been more than 1 outfeed tables like that posted here on the Creek. Try this search on google:

site:sawmillcreek.org outfeed table fold down

[Ole Anderson]

Here you go (on a G1023 with HTC rails). From Wood magazine plans, but enough detail in the pics to reproduce. Being supported as it is from the saw, you are somewhat limited in size, but it balances 7' lumber.

Edit: I skimmed the video mentioned by Doug in Post #6, that is the table I built, I scaled it down a bit as you really don't need the full width. Also the folding, adjustable sliding dovetail support leg is way too complicated to build and use, so I just made a removable single piece support which is rock steady.

[Alan Lightstone]

There's a very good project showing one on Lumberjocks. Search for Tedth66.

No specific plans there, but easy to figure out.

[Doug Garson]

How about this one? https://www.youtube.com/watch?v=Pt6s3rzF8jg

[Pete Janke]

Here's my Jim Becker knockoff mounted on my Grizzly G0691. The folding table is an old unused drafting table. The fixed table is plywood covered with cheap laminate flooring trimmed with poplar. It also serves as an assembly table.