Dovetail Cutter

[Bruce Page]

I bought this off of Craigslist today along with a bunch of other re-sharpened endmills. It's 2-1/4 diameter by 60° with a 1" shank.
I figure I could make some serious sliding Dovetails with it. :eek:

[Bruce Wrenn]

Now all you need is a Bridgeport, with power table, and you will be in business. Hope you didn't pay too much

[Bruce Page]

Nah, I'll rig it up to run in my router table. My PC 7518 should handle it no problem.

[pat warner]

If that 7518 accepts that 1" shank tell me how you did it.