Gene Jameson
04-14-2016, 11:02 PM
My epilog 36 ext 75W tripped its built in breaker twice today. I have noticed over the past month that I have had to reduce my speed to get good yield when cutting 3mm Baltic birch. However, today it tripped the internal breaker after about 20 minutes of cutting. I restarted it then ran another job and the same thing happened. It was only 70 degrees in the shop so I don't think it was overheated. I am currently waiting to hear back from tech support but wondered if any one here had experienced this. Is it time for a new tube or power supply or something else. Thanks, Gene