Maple bowl

[Leo Van Der Loo]

I somehow got this bowl picture double and can’t seem to remove one of them.

I finished this bowl 1n 2003 and never got a good picture of it, (before a digital camera, though LOML did make one for the sold archiving she always did (film camera))

I was able to make some pictures last week and also from another bowl, both have been used for all this time, this one being their fruit bowl, (had to remove a dozen tangerines and some bananas before making the pictures)

I loved that the bowl held up so well and the color improved to my liking, so here a couple of pictures.

The bowl is about 17” across, made the pictures with a piece of drywall as background, worked reasonable well.

Yes comments are welcome :)

335559 335555 335556 335557


335516
335516

[Fred Belknap]

Beauty and perfection in a simple bowl.:)

[robert baccus]

Very simple and very nice.

[Leo Van Der Loo]

Beauty and perfection in a simple bowl.:)

Thank you Fred, hope you like the additional pictures :D

[Leo Van Der Loo]

Very simple and very nice.

Thank you Robert :), the owners are very pleased with them.

[Leo Van Der Loo]

The thing that pleased me much is how well the Polymerized Tung Oil finish has stood up with no additional coating over the original finishing, that gives me a good feeling that the finish is a good one as I used them for all the other pieces that people have purchased over the years :D

[Eric Schatz]

Can you tell me more about your finishing process?

[Leo Van Der Loo]

Can you tell me more about your finishing process?

Eric I sand my pieces to a high grit, often 320 or 400, hold it out in good light so you will see any and all scratches, remove those, as the oil will bring out the grain but also any bad sanding marks.

Then I follow the regiment that is here on this HOW TO, for the Sealer I thin with real Turpentine up to 35% or so for better penetration.

I use the so called high gloss PTO (Polymerized Tung Oil) after that, so no thinning, just follow the rules and work in and keep the oil and workpiece in a warm environment.

I use a closable Beer bottle to store my PTO in, keep it right full with water, as the oil will float on top, if you don’t the PTO will react with the oxygen in the air and you can not undo that, you’ll just have to throw it out when it hardens up as it is than useless. HTH.

335682