steven c newman
03-31-2016, 7:06 PM
Well, went to a store to look around a bit, as I was about and about in the area. I had stopped to see a relative, whom happened to have a wire-welder. I had a plane iron to repair. He got it all welded up, and cleaned up, left me with very little to smooth out. After a bit of sharpening, it is back in the Ohio Tool Co. No.07......
Now, about that store I went to....was looking for a couple other plane irons...found one, tapered, made for a coffin smoother. Already have a chipbreaker to match. Problem was it was stuck to a Rusty& Krusty Razzee plane. well, might as well see IF it would be a "package deal"?? Hmmm, $5.36 ( counting sales tax) for the mess. Razzee turned out to be an Ohio Tool Co. no. 035. with "issues"
Missing the front knob and the screw.....dug both out of spares
Rear handle ended about ...3/4" up from the bottom. Dug out both the new tote and the long bolt from spares.....walnut, will just have to do
Switched out the lever cap, as another 035 I am selling needed the correct one
Iron was tuned up.....chipbreakers were swapped out to better fit the two planes, stanley iron to the replacement plane, Ohio iron to the sold plane. Chipbreakers didn't get switched, though. Adjusters didn't quite match.
Gave the #0 7 a test drive..
334938
Seemed to hold up.....next, the cleaned up replacement 0 35
334939
The adjuster wheel on this one is right hand thread....
334940
Doesn't look too bad, for a $5 plane? As for the one it replaces in the shop?
334941
Twins??
334942
The 0-7 is sitting beside the two....not too bad a day...:rolleyes:
Now, about that store I went to....was looking for a couple other plane irons...found one, tapered, made for a coffin smoother. Already have a chipbreaker to match. Problem was it was stuck to a Rusty& Krusty Razzee plane. well, might as well see IF it would be a "package deal"?? Hmmm, $5.36 ( counting sales tax) for the mess. Razzee turned out to be an Ohio Tool Co. no. 035. with "issues"
Missing the front knob and the screw.....dug both out of spares
Rear handle ended about ...3/4" up from the bottom. Dug out both the new tote and the long bolt from spares.....walnut, will just have to do
Switched out the lever cap, as another 035 I am selling needed the correct one
Iron was tuned up.....chipbreakers were swapped out to better fit the two planes, stanley iron to the replacement plane, Ohio iron to the sold plane. Chipbreakers didn't get switched, though. Adjusters didn't quite match.
Gave the #0 7 a test drive..
334938
Seemed to hold up.....next, the cleaned up replacement 0 35
334939
The adjuster wheel on this one is right hand thread....
334940
Doesn't look too bad, for a $5 plane? As for the one it replaces in the shop?
334941
Twins??
334942
The 0-7 is sitting beside the two....not too bad a day...:rolleyes: