Gene Uselman
03-20-2016, 3:33 PM
I am switching from a Leetro to a Ruida 320-A control and am having problems with where the Limit switches should be attached. I 'think' they should be as below:
CN3 #1 &4 - Z limit sw
CN4 #1,3,5- X&Y limit sw
and the (glass 130watt) laser tube should be connected to CN6 #1,3,4
I would be forever grateful if some one could verify this on their machine. Thanks Gene
CN3 #1 &4 - Z limit sw
CN4 #1,3,5- X&Y limit sw
and the (glass 130watt) laser tube should be connected to CN6 #1,3,4
I would be forever grateful if some one could verify this on their machine. Thanks Gene