Graham Taylor
03-16-2016, 12:59 PM
Q. What is the shortest time you switch your machine on for?
I try not to switch it on for anything less that 3 hrs because I am quite busy in the shop and packing orders so my cutting time is usually at the end of the day or 1st thing in the morning.
Q. I was told/read somewhere that the Trotecs dont like a cold start when 1st switched on so do you guys have a min temp you switch it on?
I usually turn on a heater which I have blowing at the rear of the machine it if it is a bit chilly to warm it up but is this necessary?
I try not to switch it on for anything less that 3 hrs because I am quite busy in the shop and packing orders so my cutting time is usually at the end of the day or 1st thing in the morning.
Q. I was told/read somewhere that the Trotecs dont like a cold start when 1st switched on so do you guys have a min temp you switch it on?
I usually turn on a heater which I have blowing at the rear of the machine it if it is a bit chilly to warm it up but is this necessary?