Keith Downing
02-22-2016, 3:51 PM
About 18 months ago I bent the blade guard on my Jet table saw (JTAS-10XL). Since then I've been avoiding the saw whenever possible as the feed binds a lot and i didn't have the time to research the issue. To complicate matters, the parts have been discontinued for the saw so I'm definitely going to have to choose an after market product.
Anyone with this saw have suggestions for a riving blade or other aftermarket safety piece? I've seen some other discussions here, but even slight differences in the saw seem to make a big difference in what's available that fits properly.
Thanks for any input in advance.
Anyone with this saw have suggestions for a riving blade or other aftermarket safety piece? I've seen some other discussions here, but even slight differences in the saw seem to make a big difference in what's available that fits properly.
Thanks for any input in advance.