Marcello Apa
02-17-2016, 9:57 PM
Hi all.
I'm I a little bit of a dilemma.
I have a cabinet with a set of 5 drawers stacked on each other.
1) drawers are inset
2) drawers are wooden glide system (Dado in drawer side)
3) no dividers between drawers
Drawers fronts are all inset of the carcass with 3/32" gap around each drawer.
How can I make a drawer out stop? Pin method pushed out from inside of drawer won't work as tolerances are to tight.
Only think I can think of is drill/cut some sort of hole in back of drawer and attach a "leash from the back of drawer to back of cabinet.
Any opinions / ideas would be loved.
Thanks, Marcello
I'm I a little bit of a dilemma.
I have a cabinet with a set of 5 drawers stacked on each other.
1) drawers are inset
2) drawers are wooden glide system (Dado in drawer side)
3) no dividers between drawers
Drawers fronts are all inset of the carcass with 3/32" gap around each drawer.
How can I make a drawer out stop? Pin method pushed out from inside of drawer won't work as tolerances are to tight.
Only think I can think of is drill/cut some sort of hole in back of drawer and attach a "leash from the back of drawer to back of cabinet.
Any opinions / ideas would be loved.
Thanks, Marcello