PDA

View Full Version : fabric stamp



Cindy Rhoades
02-09-2016, 5:50 PM
I have a customer that is wanting a stamp made so that she can stamp a design on fabric with fabric paints. What would be the best material for this? It is a very detailed design.

Mark Sipes
02-09-2016, 6:41 PM
Interesting idea. What size is the image. Any Idea what the material is she wants to stamp? I would be concerned that the stamp would get filled with paint and just print a blob if the material is thick. A cotton sheet on a hard surface would hold an image. A good silk screen might be a better choice... but I'm just throwing my limited printing knowledge out there...

.

Steve Clarkson
02-09-2016, 6:53 PM
I would suggest a lino block.

Mike Null
02-09-2016, 7:32 PM
I think I'd go with rubber stamp material. You can get the detail with that.

But I agree with Mark that screening would be the best especially for higher volume work.

Cindy Rhoades
02-10-2016, 11:25 AM
It is going to be small about .5" x 2" It will not be high volume usage, it is for a very special project she wants to do there is not a lot of detail in the image she wants to use but it is special. They are foot prints of a tiny baby that passed and when the hospital took prints they did a terrible job. I have cleaned up the image best I can. I may have to make a few different types to see which one will work best. I know I will probably lose money on this order but I also think I will end up making money in the long run off of this deal.

Mark Sipes
02-10-2016, 1:28 PM
1st post - What would be the best material for this? It is a very detailed design. It is going to be small about .5" x 2" It will not be high volume usage, it is for a very special project she wants to do there is not a lot of detail in the image

A small block of hardwood should be adequate.........the two posts confused me, but that is an easy task these days.....

.

Cindy Rhoades
02-10-2016, 5:28 PM
In a way it is detailed but you don't have the ridges like a good print would have so I guess it is a bit in between. My mind was thinking faster than my fingers were typing sorry for the confusion. Thanks for the help I will try it with hard wood first and see what happens if that doesn't work I will pull out the stamp material.

Jerome Stanek
02-11-2016, 6:52 AM
how about corian

Chuck Stone
02-12-2016, 11:53 AM
Linoleum works best for this, but it isn't so easy to find anymore. I just scored some 12x12 tiles from the back room of an old time hardware store.. ancient stock, cobwebbed .. the room may have been haunted and the door last opened sometime during the Truman administration. But it engraves beautifully. Lino blocks (found at hobby stores) might work, but I've been told they are usually too soft for fabrics. I don't know that for sure, but many use them for paper and card stock. Next would be boxwood, which is often used in Indian print blocks for fabrics. You would oil the block after engraving in reverse (and inverted) and once the oil dries it should be ready to use. Hard maple will also work well for a short run like this, it doesn't need to last for decades, just long enough for the project.

Cindy Rhoades
02-12-2016, 5:14 PM
Thanks Chuck