Roy Sanders
01-03-2016, 11:35 AM
Hello Citizens
I have a new conundrum. I bought some Buna N rubber to make a gasket for my vacuum chamber. I wish to cut it to dimension with my laser. I read several sites that indicate this is doable up to 3/4".
Has anyone in this community had experience in actually cutting rubber with the Laser? I want to know if there are concerns, suggestions, etcetera.
Thank you in advance for your thoughts
Roy :confused::eek:
I have a new conundrum. I bought some Buna N rubber to make a gasket for my vacuum chamber. I wish to cut it to dimension with my laser. I read several sites that indicate this is doable up to 3/4".
Has anyone in this community had experience in actually cutting rubber with the Laser? I want to know if there are concerns, suggestions, etcetera.
Thank you in advance for your thoughts
Roy :confused::eek: