Laser cutting Buna N Rubber

[Roy Sanders]

Hello Citizens

I have a new conundrum. I bought some Buna N rubber to make a gasket for my vacuum chamber. I wish to cut it to dimension with my laser. I read several sites that indicate this is doable up to 3/4".

Has anyone in this community had experience in actually cutting rubber with the Laser? I want to know if there are concerns, suggestions, etcetera.

Thank you in advance for your thoughts

Roy :confused::eek:

[Joe Pelonio]

I have cut several different kinds of rubber up to 1/4" thick, and other than rough edges on some types, have not had any problems. Always check the MSDS before using a new material, however, and look for reactions to extreme heat, and toxic or corrosive fumes like you get from PVC. I looked up this material and it looks OK but I'm not a chemist.

[Dave Sheldrake]

I use Buna - N to make sealing rings for the nuclear industry

Cuts well

STINKS BAD !!

[Roy Sanders]

Thank you very much for your replies I will proceed. I too looked it up; I wanted experience to speak louder than internet. Theoretical versus experiential? I go with the latter most often

Roy