PDA

View Full Version : Fail to load .MOL



Norm Senkel
12-17-2015, 9:18 AM
I have several GWeike lasers I use for manufacturing fixturing and support. My go to is a 1512 that has run flawlessly for 2 years...until now. I transfer jobs via flash drive after converting ACAD DXF to MOL via 5.3. The 1512 is now accepting the downloads, but running "test" for material alignment results in no movement. I suspect the files are not downloading properly, but want to see if anyone has encountered this before. I have eliminated the internal USB cable as a cause.