Ben Conner
12-13-2015, 12:55 PM
Hi,
I've had a 10-20 sitting in the original box for years (sad to say) and finally took it out and set it up. The sanding drum itself turns, but the conveyor belt drive shaft does not. In the troubleshooting guide it lists as a possible cause that the shaft coupler might not be attached.
Where does this hang out on the 10-20 model? I don't see it in the parts diagram.
Thanks!
--Ben
I've had a 10-20 sitting in the original box for years (sad to say) and finally took it out and set it up. The sanding drum itself turns, but the conveyor belt drive shaft does not. In the troubleshooting guide it lists as a possible cause that the shaft coupler might not be attached.
Where does this hang out on the 10-20 model? I don't see it in the parts diagram.
Thanks!
--Ben