Slowing the Trotec Rotary

[Jack Clague]

Hi all,

Just a quick question, I'm trying to find a way to slow the rotary when it moves between engraving points, the speed is causing some issues with the object i am engraving (heavy and not the tightest connection to the cones so it wobbles under high speed)

Any ideas?

[Mark Sipes]

I believe you can achieve the results you want by changing the Setting in the Service Section under Acceleration X and Y Values . Restore after your job is complete.


Page 74 of the Software manual.


.

[Jack Clague]

Thanks Mark, I will look into that and see if that helps on a test piece before attempting another engraving