Wade Samuelson
09-03-2005, 2:33 AM
Hi again,
I am going to be putting together a little stand-alone shelf unit for my wife (25" tall, with 2 shelves and a top). I plan to use a dado blade on the side pieces and then put the shelves in the grooves. However, the bottom shelf will be about an inch off the ground which means I have to cut the groove in the side piece accordingly. I don't have a crosscut sled for my little contractor table saw, and I don't know how I would slide the two foot side piece along uniformly and a cut my groove an inch from one end.
Can I put my dado blade on my SCMS? It will cut the 12" side piece. Or is there a way to make it work on my TS?
Sorry if I didn't explain that too well, but I would appreciate any help you have. Thanks!
I am going to be putting together a little stand-alone shelf unit for my wife (25" tall, with 2 shelves and a top). I plan to use a dado blade on the side pieces and then put the shelves in the grooves. However, the bottom shelf will be about an inch off the ground which means I have to cut the groove in the side piece accordingly. I don't have a crosscut sled for my little contractor table saw, and I don't know how I would slide the two foot side piece along uniformly and a cut my groove an inch from one end.
Can I put my dado blade on my SCMS? It will cut the 12" side piece. Or is there a way to make it work on my TS?
Sorry if I didn't explain that too well, but I would appreciate any help you have. Thanks!