Roger Lueck
12-02-2015, 8:07 PM
In Laserworks 6.0 are you able to save a previously used x-y location for future or repeated use? An example would be when running a large number of identical pieces there is a need to insert a single piece job into your schedule that requires a different x-y starting point on the engraving table due to size or shape of the single piece job.
The scenario would be in an order of execution similar to this:
1. Establish the x-y starting position using the origin key on the LCD for the first job
2. "Save" the x-y starting position of the first job
3. Begin engraving the first job
4. Establish a different x-y starting position for the second job using the origin key on the LCD
5. Engrave the second job
6. Return to the "saved" x-y starting position used for the first job
7. Resume engraving the first job
Thank You,
Roger A. Lueck
Morntech MT-3050
50 Watt
Laserworks 6.0
The scenario would be in an order of execution similar to this:
1. Establish the x-y starting position using the origin key on the LCD for the first job
2. "Save" the x-y starting position of the first job
3. Begin engraving the first job
4. Establish a different x-y starting position for the second job using the origin key on the LCD
5. Engrave the second job
6. Return to the "saved" x-y starting position used for the first job
7. Resume engraving the first job
Thank You,
Roger A. Lueck
Morntech MT-3050
50 Watt
Laserworks 6.0