PDA

View Full Version : Direct Laser Printing



Nathan Shaffer
12-01-2015, 11:48 AM
Good Morning All,
This may be off subject, has anyone played around with a resin based 3d printer? And has anyone had recent dealings (last 6 months) with Full Spectrum? They have largest printer that I have been able to find, wondering if it would be too big a head to try to work with them.

Thank you All.
Nathan

Dan Hintz
12-01-2015, 12:26 PM
Yes to the first question, I own one.

All I'll say on FSE is you are taking your life into your own hands (figuratively speaking, of course). You may get lucky and get a working machine without issues... or you may go the other direction. And may God have mercy on your soul if you get the latter. Research the older threads about them.

Bert Kemp
12-01-2015, 12:39 PM
Seriously FSL are really bad to deal with most here will tell you to look elsewhere. But to each his own.

Dave Sheldrake
12-01-2015, 12:45 PM
I have sls / sla and powder layer from Robox through to Z-Corp

much of the time they are expensive boat anchors for business use.

The materials as yet haven't caught up with the technology :(