Looking for epoxy recommendations for filling some blind knot holes in reclaimed wood

[Justin Pfenning]

I purchased a stand and made a top from reclaimed oak pallet boards. I would like to fill some blind knots, to keep them from filling up with stuff as we use the stand. We plan to put our Harbor Freight lathe on this stand, so the fill doesn't have to be perfect. I was hoping to find some epoxy at Menards, and I see they carry JB woodweld. Would this work? They also have several other epoxy types from loc-tite. Any recommendations or advise? The JB woodweld says it sets in 6 minutes, and reaches full cure in 1-3 hours. If the epoxy is chemically set, I'm guessing the thickness doesn't effect the cure time.

http://i156.photobucket.com/albums/t23/pfenningv/Mobile%20Uploads/61C7014B-1D46-46DD-B2E8-501DA2B835B5_zpsvhmlp9ed.jpg (http://s156.photobucket.com/user/pfenningv/media/Mobile%20Uploads/61C7014B-1D46-46DD-B2E8-501DA2B835B5_zpsvhmlp9ed.jpg.html)

Justin

[fred woltersdorf]

If you just want functionality use Bondo or Dap Plastic Wood which is stainable.

[Ben Grunow]

No experience with any of those brands but I would suggest you make sure the epoxy is very well mixed before filling those holes. Thickness shouldnt matter here but if you mixed a huge batch (again not going to happen here) like a quart at once you can have an exothermic reaction and build some serious heat.

Just squeeze out a tube and mix it thoroughly with a putty knife and then pour it in carefully- small cup might work best. Might be careful not to get it all over the boards if you plan to stain.

[Jim Finn]

I use a surfacing resin to fill knots in cedar . It is a product called "Z-poxy". Available at hobby shops.

[Prashun Patel]

Bondo may be the easiest to work with. It will have enough body to fill those voids in one pass. With epoxy, you'll probably need a couple if you use it neat.

If you want to use epoxy, I'd mix up an epoxy and sawdust slurry and pack the voids with that.

[Mike Cutler]

Were there any tubes of "Quickwood" at Menards?
Get a tube of dark walnut Quickwood and you'll be done in 10 minutes. Quick wood will machine just like wood. It doesn't take a stain though.