View Full Version : Image thoughts

Kevin Clark2227
11-17-2015, 4:36 PM
I have been tasked with lasering a piece of wood, most likely a lightly grained maple as it is difficult to find alder around here. But any thoughts on getting this image to laser right? A lot of brick work.325462

Jack Clague
11-17-2015, 4:44 PM
I'd be tempted to try a test piece exactly as it is, its a 2 tone image so should engrave pretty well under 300-400 dpi on most woods.

Bruce Volden
11-17-2015, 6:10 PM
How large of engraving is needed? I wouldn't hesitate to try. It looks a little out of square though.


Bert Kemp
11-17-2015, 6:34 PM
yes try as is but straighten it out first:D

Kevin Clark2227
11-17-2015, 9:53 PM
They are looking for a size of 8"X10" I had to reduce it to upload it. I'll give it a college try.

Kev Williams
11-18-2015, 1:38 AM
--I took it and darkened it a bit and tried to thin out the darker areas to leave more room for the lighter areas...


Dan Hintz
11-18-2015, 6:20 AM
It's pure B&W, so there's really not much to do to it. I might run it through a sharpening filter to make the edges standout a bit more, but I don't think this image really needs it.