Justin Jump
11-17-2015, 7:57 AM
OK all, one of the last things to finish up the kitchen is to figure out my crown molding, and I need some input.
A few rookie mistakes put me into a bit of a dilemma.
The original plan was to relocate all the plumbing and eliminate the bulkhead above the sink and wall cabinets seen in the one picture. After demo, we realized that without some major restructuring, pulling toilets and changing flanges in the bathrooms above, it would be too much, so I opted to keep the bulkhead, which is 6” tall.
The bad part is that I had already built the carcasses and frames for the cabinets on the other wall, the wall oven, refrigerator and the small pantry cabinet. The issue here is that from the top of the cabinet to the ceiling is only 3” on this wall.
Add into the issue I put a can light really close to the corner wall cabinet, leaving me only about 1 ˝” of clearance if you extend the wall cabinet up to the ceiling.
That being said – I need some help coming up with a crown that will look somewhat similar to each side, the sink side having a 6” tall reveal, and the frig side having a 3” tall reveal.
The last picture shows something I found on web, I could easily use this option, and it would just be 6” and 3” tall….
Anyone else had a similar situation and had a clever fix for an issue like this?
THX
325427325428325429
A few rookie mistakes put me into a bit of a dilemma.
The original plan was to relocate all the plumbing and eliminate the bulkhead above the sink and wall cabinets seen in the one picture. After demo, we realized that without some major restructuring, pulling toilets and changing flanges in the bathrooms above, it would be too much, so I opted to keep the bulkhead, which is 6” tall.
The bad part is that I had already built the carcasses and frames for the cabinets on the other wall, the wall oven, refrigerator and the small pantry cabinet. The issue here is that from the top of the cabinet to the ceiling is only 3” on this wall.
Add into the issue I put a can light really close to the corner wall cabinet, leaving me only about 1 ˝” of clearance if you extend the wall cabinet up to the ceiling.
That being said – I need some help coming up with a crown that will look somewhat similar to each side, the sink side having a 6” tall reveal, and the frig side having a 3” tall reveal.
The last picture shows something I found on web, I could easily use this option, and it would just be 6” and 3” tall….
Anyone else had a similar situation and had a clever fix for an issue like this?
THX
325427325428325429