View Full Version : Delta 14" Bandsaw Drive Belt
Dimitrios Fradelakis
11-14-2015, 9:13 AM
I am going to be upgrading the motor on my 14" Delta Bandsaw tomorrow and would like to replace the belt at the same time. Does anyone have a generic part number for said belt? I'm looking for a cogged V belt if possible and would like to pick it up today.
glenn bradley
11-14-2015, 10:01 AM
No part number but, just stop by your local Harbor Freight and pick up some of this (http://www.harborfreight.com/vibration-free-link-belt-43771.html) and your all set. It is actually made by Accu-Link and is of good quality.
Bruce Page
11-14-2015, 12:39 PM
+1 on switching to a link belt. It really helped to reduce vibration on my old Delta 14".
Myk Rian
11-14-2015, 12:51 PM
I use link belts to get the correct length of a permanent belt. They are not an end-all solution.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.