Delta 14" Bandsaw Drive Belt

[Dimitrios Fradelakis]

I am going to be upgrading the motor on my 14" Delta Bandsaw tomorrow and would like to replace the belt at the same time. Does anyone have a generic part number for said belt? I'm looking for a cogged V belt if possible and would like to pick it up today.

[glenn bradley]

No part number but, just stop by your local Harbor Freight and pick up some of this (http://www.harborfreight.com/vibration-free-link-belt-43771.html) and your all set. It is actually made by Accu-Link and is of good quality.

[Bruce Page]

+1 on switching to a link belt. It really helped to reduce vibration on my old Delta 14".

[Myk Rian]

I use link belts to get the correct length of a permanent belt. They are not an end-all solution.