View Full Version : PowerCut4311

Julian Ashcroft
11-01-2015, 3:02 AM
My new eBay purchased laser (I'll update on that purchase soon) came with software called PowerCut4311, I had never heard of it before and first look I thought it was quite basic and didn't have the (limited) functions that I was used to with LaserWorks 6. The manual went into the basics, but there is a lot more to it than the manual explains and it turns out to be pretty good.

Somethings though need adusting, just as corners, on a corner, the laser slows right down to around 8mm a second when the straight line cutting speed is 45mms. So I need to be able to speed up the corner travel a bit or turn the laser power down, to make any changes I need a password, so does anyone know what it is?

Julian Ashcroft
11-03-2015, 11:07 AM
Managed to find it, not so hidden in the config file.