View Full Version : Playing...lol
Ron Sleeman
10-23-2015, 12:14 AM
Playing with my new machine today. Boy the etching on glass was alot more than I thought, very smooth.The bear in a bear was only 3'' long, end of the trail is 2'' long, the e eagle is 2'' long. I'm very happy.
Thanks Ron Sleeman
Ron Sleeman
10-23-2015, 12:15 AM
sorry for the sideways pictures..lol..
Jack Clague
10-23-2015, 12:35 AM
Wonderful Work Ron, what masking or covering did you use over the glass before engraving
Ron Sleeman
10-23-2015, 12:39 AM
Hello Jack: I did not masked them or any covering on them. I just used Trotec's settings.
Jack Clague
10-23-2015, 12:43 AM
Nice work, I'm surprised the Trotec settings for me were way to low to engrave into the glass, I followed the guide from Trotec Canada's youtube page using 100% power and about 60% speed for an 80Watt but they suggested a masking tape or wet medium to disperse the surface heat to stop flaking.
your glasses came out so well
Ron Sleeman
10-23-2015, 12:52 AM
Jack I used 100% power and 40% speed with Resolution 500 with halftone...Jarvis
Ron Sleeman
10-23-2015, 12:56 AM
Sorry Jack, I have a Speedy 400 with 80 watt
Jack Clague
10-23-2015, 1:03 AM
Sorry Jack, I have a Speedy 400 with 80 watt
Thanks Ron that gives me something to work from as an alternative, Yes I was using Jarvis as well
Keith Winter
10-23-2015, 8:12 AM
Very nice Ron!
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.