Stopped Tapers

[Prashun Patel]

I like this detail for a mirror frame I'm making.

How can I plane/cut a consistent taper along the edge, stopping short before the corners. Is there a safe way to plunge cut this on the table saw or router table?

My fall back is an angle grinder, block plane and rasp.

[Lee Schierer]

That taper looks like it was done with a router with a large guide bearing. Because the bearing won't go into the corner, it leaves the tapered look that you see in the photo.

[Andrew Hughes]

I was thinking the same as Lee.Just not sure what the bit looks like.

[Mel Fulks]

Lee is certainly right. An interesting question here: will talented op still find an easy detail worthy?

[Kent A Bathurst]

Draw lines, fire up Mr. Band Saw with table tilted, pay attention.

Fair and finish with multiple members of the Auriou clan.

[Prashun Patel]

I suppose you're right. I find that inside corner appealing on this shallow chamfer. But now that you say it, I'm getting turned off... :( Although Kent's suggestion sounds good.