Walt Langhans
10-16-2015, 11:31 AM
Hi guys,
Well My Rayfine is giving me issues again.
I just replaced the power supply less then a week ago, and I was running a job and only half of it got cut out. So I pulsed the laser and I'm only reading about 6mA. So... how do I tell if it's the tube (which is an RECI an probably dosen't have more than 200 hours on it at this point), or power supply? Granted it could be a controller issue, but I would like to check out the tube and power supply first.
Thanks!
Well My Rayfine is giving me issues again.
I just replaced the power supply less then a week ago, and I was running a job and only half of it got cut out. So I pulsed the laser and I'm only reading about 6mA. So... how do I tell if it's the tube (which is an RECI an probably dosen't have more than 200 hours on it at this point), or power supply? Granted it could be a controller issue, but I would like to check out the tube and power supply first.
Thanks!