Jack Clague
10-15-2015, 1:25 AM
Hi All,
I have a client asking if I can source and a material suitable for multi rotor craft, for those that do not know multi rotors are radio controlled drones that use 3-12 engines and require thin strong light weight sheets for their construction, the designs usually has one lower layer and an upper layer of composite material separated by spacers, normally 2-3mm Carbon sheet or Fibreglass epoxy sheet (G10) is used
I need to find out if there is a material out there that has the below qualities or close to:
Structural strength close to our greater than G10 (Fibreglass Epoxy Resin Sheet)
Weight close to or less than the same
Able to be cut using a CO2 laser
Any Thoughts?
Jack
I have a client asking if I can source and a material suitable for multi rotor craft, for those that do not know multi rotors are radio controlled drones that use 3-12 engines and require thin strong light weight sheets for their construction, the designs usually has one lower layer and an upper layer of composite material separated by spacers, normally 2-3mm Carbon sheet or Fibreglass epoxy sheet (G10) is used
I need to find out if there is a material out there that has the below qualities or close to:
Structural strength close to our greater than G10 (Fibreglass Epoxy Resin Sheet)
Weight close to or less than the same
Able to be cut using a CO2 laser
Any Thoughts?
Jack