PDA

View Full Version : Need advice on adhesive used to adhere new panels to end gables.



Joel Wesseling
10-10-2015, 1:25 PM
Hi All,

I'm replacing all doors and end gables on a kitchen. I Veneered some 1/4 particle board panels to match the doors, and these need to be attached to the existing end gables of the original cabinets.

The panels have some warping and I need to stick them flat but I don't have the ability to apply pressure while the adhesive dries.

I'm certain Contact Cement would work but prefer to use something from a CALKING GUN.

Any suggestions? I need instant and permanent bond so the panels won't spring back.

Thanks!

Tom M King
10-10-2015, 1:26 PM
323093Powergrab... Coffers for this ceiling were made before putting up with MDF and Powergrab.

Joel Wesseling
10-15-2015, 9:00 AM
Thanks Tom.

I wanted to try powergrab but couldn't find it for sale around here.

I used contact cement and it worked perfect.

Thanks!

Chris Padilla
10-15-2015, 1:27 PM
Be sure to report back when they fall off, Joel. :)

I hope they don't but contact cement in a moisture laden area like a kitchen...might not last. Then again, it may last just fine. ;)

Jerome Stanek
10-15-2015, 7:01 PM
Be sure to report back when they fall off, Joel. :)

I hope they don't but contact cement in a moisture laden area like a kitchen...might not last. Then again, it may last just fine. ;)


So all those counter tops fail over time