Aaron Conway
10-03-2015, 1:18 PM
Had a blast making this little shop accessory. As I'm getting back into ww'ing after a few years away I've been trying to find projects with a variety of tasks to complete and this fit the bill perfectly. Lots of similar designs on the web that I used as inspiration. Overall, very happy with the outcome.
322715
It's made of a double layer of 1/2" plywood. The layers are glued together but before I glued them together I drilled three holes in the bottom layer and routed a recess for t-track bolts I used to attach to the drill press table.
322716
I didn't want to see the plywood layers so I added a poplar band on three sides. The fence can slide off the back easily so I can add/remove t-track accessories as needed.
322717
I've also already cut four replacement squares so when it gets chewed up I can quickly swap it out. It's been a long time since I spent this much quality time in the shop and very glad I did.
Onto the next project.
Aaron
322715
It's made of a double layer of 1/2" plywood. The layers are glued together but before I glued them together I drilled three holes in the bottom layer and routed a recess for t-track bolts I used to attach to the drill press table.
322716
I didn't want to see the plywood layers so I added a poplar band on three sides. The fence can slide off the back easily so I can add/remove t-track accessories as needed.
322717
I've also already cut four replacement squares so when it gets chewed up I can quickly swap it out. It's been a long time since I spent this much quality time in the shop and very glad I did.
Onto the next project.
Aaron