Quick question about rubbing out

[Daniel Smith]

I'm rubbing out a shellac finish on a project with a couple of inside corners and a bunch of cock beading. Any tips on how to get into the last 1/16th of an inch to get an even sheen all the way to the edge? The steel wool/cork block combo I'm using doesn't seem to want to get all the way into the corner.

[John TenEyck]

Switch to Abranet and cut it to fit your cork block. That should allow you to get into the corners. If not, cut a wood block so that it will, glue a piece of sheet cork to it, and use that with the Abranet.

John