Bill Brush
09-30-2015, 12:28 AM
Ok, so the mounting plate/motor housing broke, and I found a place to repair it, but I can't get the bloody armature out of the housing. It looks like it's the front bearing is pressed into the housing, the the armature goes through the housing.
I was hoping to find someone who's done it before. Currently the plan is to heat up the housing with my paint stripper gun and press out the armature with my drill press.
Here's a picture of the motor: http://c.searspartsdirect.com/lis_png/PLDM/50024793-00004.png
Thanks in advance.
Bill
I was hoping to find someone who's done it before. Currently the plan is to heat up the housing with my paint stripper gun and press out the armature with my drill press.
Here's a picture of the motor: http://c.searspartsdirect.com/lis_png/PLDM/50024793-00004.png
Thanks in advance.
Bill