Blum Hinges and Undermount Slides

[George Bokros]

Does Blum have a concealed hinge that will work with inset doors? If so what model #?

What Blum slides and locks will work with inset drawers?

Thanks

[Martin Wasner]

The full crank 110º clip top hinges is what I use. You have to plan your pockets around the mounting plates. 18mm = 3/4", 9mm = 3/8", 6mm = 1/4" I think they are drilled at 21.5mm, I don't remember what the set back is on the plates.

There was just a thread about the locking devices.

[David Zaret]

i use crates of these for inset work. the specific hinges and plates depend on your construction technique. if your face frames hang to the inside of the cabinets, you can use the half cranked (71B3650, screw-in) with the 9mm plate, 175H5030.21. if you mount your inset such that the box "appears" euro, use a full cranked hinge and 0mm plate.

the slides, tandem undermounts work (563H*), and there is a special adjustable catch plate for the front of the drawers.



Does Blum have a concealed hinge that will work with inset doors? If so what model #?

What Blum slides and locks will work with inset drawers?

Thanks

[Michael Weber]

What David says. The locking device number for the 563H slides is T51.1901.PSx