Ron Ross
08-20-2015, 9:11 PM
I've been using engravelab for about 7 months since I bought my laser ( Boss 1416). Im trying to engrave leather stamps which require at least five passes. The problem Im having is if I decide to change the engrave passes from 5 to any other number, the laser will do five. I tried changing the job palette and nothing works except going back into corel and importing the image back into Engravelab and redoing the job palettes again..
I saved a file and it was set to 7 passes on engrave. I decided I only needed to do 5, but the laser continues to print 7.
It only does it for the engrave .. my cut passes work fine.
Thanks in advance
RR
I saved a file and it was set to 7 passes on engrave. I decided I only needed to do 5, but the laser continues to print 7.
It only does it for the engrave .. my cut passes work fine.
Thanks in advance
RR