steven c newman
08-16-2015, 2:10 PM
Had some scrap wood laying around, decided to do something with it. Have 7 brace drills, figured I could stash one in the tool chest, but needed a place for the rest.
Had a holder of sorts.
Had a couple 1 x4 oak scraps
Had a pine 1 x 4 scrap
Had a 1/2" x 4" Sycamore scrap
Cut the Oak at an angle on one end, dug up some 1/4" plywood. Screwed the plywood to the oak. Added the pine scrap along the bottom. after beveling the back edge
319738
Just some counter-sunk screws, and a spot of Elmer's
The "Holder"?
319739
More Elmer's, and some screws through the plywood. Needed a way to keep the braces from flopping around..
319740
And a test fit to find out where to set the second holder. Forstner bit to try to make the notches, bandsaw to finish them up. A little more Elmers, and some screws, and the Barn Wood Sycamore is in place.
Cleared a spot to set this up, OTHER than ON my bench. Loaded the til up..
319741
All but the Millers Falls holdall chuck will fit. Gave the wood a coat of BLO, and called it done. White knob one is a screw driver brace.
Just scraps, had to find some use for them...
Had a holder of sorts.
Had a couple 1 x4 oak scraps
Had a pine 1 x 4 scrap
Had a 1/2" x 4" Sycamore scrap
Cut the Oak at an angle on one end, dug up some 1/4" plywood. Screwed the plywood to the oak. Added the pine scrap along the bottom. after beveling the back edge
319738
Just some counter-sunk screws, and a spot of Elmer's
The "Holder"?
319739
More Elmer's, and some screws through the plywood. Needed a way to keep the braces from flopping around..
319740
And a test fit to find out where to set the second holder. Forstner bit to try to make the notches, bandsaw to finish them up. A little more Elmers, and some screws, and the Barn Wood Sycamore is in place.
Cleared a spot to set this up, OTHER than ON my bench. Loaded the til up..
319741
All but the Millers Falls holdall chuck will fit. Gave the wood a coat of BLO, and called it done. White knob one is a screw driver brace.
Just scraps, had to find some use for them...