Pat Philips
08-09-2015, 11:52 PM
Hi Guys and Girls
Firstly excuse my ignorance.
I have recently purchased a Trotec Speedy 100 and I am little bit confused as to the greyscale settings.
I engrave a lot of Trophy plates on laser ply and often have to pick up different tonal range in logos. I have previously used a universal laser where I can send the logo down to the laser without converting it into a bitmap hence picking up the tones.
I have noticed with the trotec that job control automatically converts to bitmap limiting the detail that i can engrave with.
I have been using the standard - stucki - setting.
My question is.. am i doing something wrong.. should i be using different settings ???
Thanks in advance
Pat
Firstly excuse my ignorance.
I have recently purchased a Trotec Speedy 100 and I am little bit confused as to the greyscale settings.
I engrave a lot of Trophy plates on laser ply and often have to pick up different tonal range in logos. I have previously used a universal laser where I can send the logo down to the laser without converting it into a bitmap hence picking up the tones.
I have noticed with the trotec that job control automatically converts to bitmap limiting the detail that i can engrave with.
I have been using the standard - stucki - setting.
My question is.. am i doing something wrong.. should i be using different settings ???
Thanks in advance
Pat