Ricc Havens
07-14-2015, 2:21 PM
I have a 3-1/2yr old Jet 1642 2hp. Used the lathe on saturday without any issues. Just went to the basement to finish a project and the lathe won't run. The front rpm display is lit up but just shows zero. But the Delta motor controller appears to be dead. Nothing showing on it's small display panel. Unplugged lathe for 30min. to see if that would allow any overload sensors to reset if that was the issue. It didn't help.
Info off the label controller show it's a
Delta S1 - Model# VFD015S21U
input: 1ph - 15.7A - 200-240v
Output: 3ph - 7.5A - 2.9kva -
Frequency range: 1-400hz
Version 2.61
To be honest - we have had a few storms this weekend. BUT no power outages and no other electronic equipment (computers, TV, DVD, digital controls on washer/dryer, microwave, electric stove, etc) has been affected by unseen and unknown electrical surges or power flickers.
Can't see any external safety/overload fuse. the manual doesn't show an internal one so not sure if there is anything inside the controller, and not an electrician so I don;t want to take it apart.
Any thoughts or suggestions?
Thanks
Ricc Havens
Elkhart, IN
Info off the label controller show it's a
Delta S1 - Model# VFD015S21U
input: 1ph - 15.7A - 200-240v
Output: 3ph - 7.5A - 2.9kva -
Frequency range: 1-400hz
Version 2.61
To be honest - we have had a few storms this weekend. BUT no power outages and no other electronic equipment (computers, TV, DVD, digital controls on washer/dryer, microwave, electric stove, etc) has been affected by unseen and unknown electrical surges or power flickers.
Can't see any external safety/overload fuse. the manual doesn't show an internal one so not sure if there is anything inside the controller, and not an electrician so I don;t want to take it apart.
Any thoughts or suggestions?
Thanks
Ricc Havens
Elkhart, IN