Scott Wadland
07-06-2015, 9:54 AM
I'm getting ready to build a router table extension for my new table saw, and I'm agonizing over where to locate the router plate and miter track. I'm planning on using a Rockler aluminum plate and a Bench Dog dual track (miter and t-track). Because of space constraints, the router table is only going to be 20" deep.
Any thoughts on where to locate the center of the plate and the center of the track (measured from the front or back edge)? I've looked at several commercially available extensions, and they vary quite a bit.
Any thoughts on where to locate the center of the plate and the center of the track (measured from the front or back edge)? I've looked at several commercially available extensions, and they vary quite a bit.