View Full Version : Uneven lines with lasercutter
Dann Ernstsen
06-11-2015, 11:36 AM
Hi All
I have a problem, my lase rcutter has begun to make uneven lines sometimes. it is in all axes (X,Y), I think is may be the guide on the rails that is not thight enough any more, have any of you experienced anything like this?
The laser is a weiker lc1612 singelhead 100 watt laser.
Mike Null
06-11-2015, 11:44 AM
Dann
Could you post a picture? That'll help us better identify the issue and solution.
Dann Ernstsen
06-11-2015, 12:33 PM
The sawtoothmarks on on the right of the picture
315547
Mike Null
06-11-2015, 1:13 PM
Dann
I have no experience with your brand of machine but my guesses are: 1. a bearing issue (clean tracks and check for smooth running if not smooth then bearings probably need replacing); 2. check belt adjustment; 3. check that pulleys are tight and clean.
Scott Marquez
06-11-2015, 1:18 PM
Can you run some box tests to help isolate it to the X or Y axis?
Scott
Dann Ernstsen
06-11-2015, 5:29 PM
Hi guys
It was the belt adjustment that was the problem, just did some cutting to chest it and it fixed the problem. The belts was adjustet around 0,5 to 1 cm, så there was a bit of slack ind them.
Thanks to you all, this is a great forum and I really like that everybody wants to help.
Dann :)
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.