Source for drill bushing

[Larry Fox]

Wondering if I can tap into the collective resourcefulness of the crowd. I am looking for what I believe is called a drill bushing. What it essentially is is a piece of steel that is about 3/4" long with a OD of 3/8" with a hole 3/16" in diameter drilled through the center. What I need to do is drill a hole 3/8" and then insert this bushing into the hole and drill a 3/16" hole in the center. The original hole is guided by a block with threaded drill inserts but it sits fairly far back from the start of the hole. The 3/8" bit doesn't wander but the 3/16" one does hence the need for the bushing.

I would have have thought this would be very easy to source but it is turning out to be tough to find. Anyone know where I can find such a creature?

Thanks in advance for your time

[Rick Lizek]

Piece of cake...
McMaster or Reid Supply

[Bruce Page]

A 3/16 ID x 3/8 OD x 3/4 long drill bushing will be hard to find. 3/16 ID x 5/16 OD is the norm. McMaster-Carr sells a 3/16 ID x 3/8 OD x 1/2 long, if you can live with a shorter length.

[Rick Lizek]

http://www.drill-bushings.com/cart.asp
You want the Serrata type.

[Larry Fox]

Thanks for the time guys - I really appreciate it. 1/2" is a little on the short side for what I am looking for but I think the link Rick sent is pointing me in the right direction.

[Chris Cohick]

http://www.drill-bushings.com/cart.asp
You want the Serrata type.

That is a great link. Thanks for sharing.

[Ronald Blue]

Late to the game but here is a link for a great source. We used their products a lot when I was doing tool and die work.

http://www.carrlane.com/catalog/index.cfm/26805071F0B021118070C1C510D020609090C0015480013180 B041D1E173C1B08535246

[Alan Lightstone]

Not to hijack this thread, but I've been thinking about the concept for years of getting bushings to be able to use 3/4" dogs in the 1" holes of my Sjoberg's bench. Would 3/4"ID/1"OD bushings work for that? Is there too little play in the tolerance to place and remove the dogs, or would it work if I epoxied the bushings permanently to 3/4" dogs (would that eliminate height adjustment of the dogs)?