michael reimer
05-25-2015, 9:05 AM
Hello,
I have a Shenhui and have an alignment issue that I would like to get some help with. I run through all the mortars and get it aligned perfectly and it cuts great. I move the bed to another location and it is out of alignment and will not cut.
Question: Does anyone here had a document that goes through the Bed alignment processor from the tube and all setting on the bed? I think this is my issue and I am not really sure where to start. Any help would be much appreciated. I have spent 2 full days on this issue already.
Mike
I have a Shenhui and have an alignment issue that I would like to get some help with. I run through all the mortars and get it aligned perfectly and it cuts great. I move the bed to another location and it is out of alignment and will not cut.
Question: Does anyone here had a document that goes through the Bed alignment processor from the tube and all setting on the bed? I think this is my issue and I am not really sure where to start. Any help would be much appreciated. I have spent 2 full days on this issue already.
Mike