View Full Version : looking for information on marking on Santoprene
Doug Kircher
04-08-2015, 1:54 PM
I know it can be cut. Not looking at that. What I would like to do is put a "White" mark on some Santoprene parts. Has anyone done this, and if so, are you using a CO2 or fiber....and any chance of sharing the settings you used.
Thanks,
Doug
Kev Williams
04-08-2015, 4:37 PM
After a little research--
Santoprene is injection mold-able, and is used mainly as seals (cars, washing machines, etc), and is predominately EPDM rubber with polypropylene mixed in. I doubt very much any C02 laser will make a WHITE mark. Fiber, maybe...?
Dan Hintz
04-08-2015, 5:20 PM
I know it can be cut. Not looking at that. What I would like to do is put a "White" mark on some Santoprene parts. Has anyone done this, and if so, are you using a CO2 or fiber....and any chance of sharing the settings you used.
Thanks,
Doug
You need fiber for that...
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.