Plans for outfeed table?

[David Ragan]

Anyone have plans they can share for an oufeed table for Table CS?

My shop is small, and I would prefer something hinged that would simply collapse/fold down onto the back of the saw.

Thanks!

[Dennis Aspö]

I use this design, it's very handy:
https://www.youtube.com/watch?v=Pt6s3rzF8jg

[Grant Wilkinson]

Mine is very similar to the one that Dennis linked to. I have a contractor table saw so the non-foldable part of the table is wide enough to take the hinged joint just beyond the motor. I used door hinges on mine, inset below the surface of table. It's not as pretty as the one in the video, but it has held up for a few years so far.

[scott vroom]

I built this one from the free plans offered. Jim Becker is a member and frequent poster here at SMC.


http://sawsndust.com/p-outfeed.htm

[Shawn Pixley]

I built this one from the free plans offered. Jim Becker is a member and frequent poster here at SMC.


http://sawsndust.com/p-outfeed.htm

i second. I shamelessly stole Jim's design!

[David Ragan]

Thanks, guys,

I downloaded the one from Woodworkers Journal Jan/Feb 2009 that Dennis referenced. Seems to fit my needs best.