View Full Version : Hand Saw Resharpening
Rich Riddle
03-22-2015, 8:17 PM
Where do you Neanders send your saws to be sharpened? My dad has a couple he would like resharpened. One is about 20" long and he likes that one quite a bit. Any ideas?
Judson Green
03-22-2015, 8:26 PM
DIY!
It don't go no where!
Mel Fulks
03-22-2015, 8:48 PM
Are you sure there isn't a good local guy ?
Rich Riddle
03-22-2015, 9:35 PM
Dad is one of those who would rather use tools than work on them. I thought there would be some guru everyone loved who provided this service.
Robert Norman
03-22-2015, 10:54 PM
http://www.badaxetoolworks.com/bad-axe-restoration-services.php
I haven't used their services but the reputation is second to none.
lowell holmes
03-23-2015, 8:01 AM
You might also post this in the classified section.
Terry Beadle
03-23-2015, 11:33 AM
I've used Daryl Weir in the past and can highly recommend him. Great job on restoration of a 1800's back saw.
http://home.grics.net/~weir/Old_SAWS_Restored.html
http://www.cookessharpening.com/ has gotten good reviews but I've not used them.
Dave Parkis
03-23-2015, 12:19 PM
Daryl Weir is very, very good and so is Matt Cianci. I think Daryl is west coast and Matt is in Rhode Island. Matt can be contacted thru Thesawblog
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.