Rich Ferry
03-22-2015, 2:14 PM
Hey Everyone,
So I know that with the roller rotary that it is a little bit more difficult to handle Flared Glass. I'm new here and just bought my first engraver, and of course am having problems like everyone else with the image stretching or distorting. I found quite a few posts about this issue, and found this calculator
http://www.unikatissima.de/e/?p=2117
But what would be the easiest way to fix this problem. Can I create something out of like cardboard or foam that fits on the bottom of this glass so that the diameter of the bottom is the same as the top? Would that work and just have areas where it has slightly lesser darkness? Or is using the warp function the best way?
Otherwise with this calculator how do I put this information into corel draw->laserworks so that I don't have this issue?
Thanks in advance!
So I know that with the roller rotary that it is a little bit more difficult to handle Flared Glass. I'm new here and just bought my first engraver, and of course am having problems like everyone else with the image stretching or distorting. I found quite a few posts about this issue, and found this calculator
http://www.unikatissima.de/e/?p=2117
But what would be the easiest way to fix this problem. Can I create something out of like cardboard or foam that fits on the bottom of this glass so that the diameter of the bottom is the same as the top? Would that work and just have areas where it has slightly lesser darkness? Or is using the warp function the best way?
Otherwise with this calculator how do I put this information into corel draw->laserworks so that I don't have this issue?
Thanks in advance!