Josh Jackson
03-18-2015, 9:58 PM
Today has not been my day. Bottom line is my machine got bumped around while moving due to my friend redoing the restraints. Nothing visibly broken, takes orders, and the bed moves.
However, I have a massive order tonight and the machine begins engraving, but after a few passes stops in about five inches from the right side. After some examination all I can figure is the air assist line (which is not hooked up to a pump) is kinking as it is being pushed to the right, this pressure is causing enough resistance to make the 'X/Y disabled X' message.
My question is can anyone provide insight in how to fix this? A quick look through the forum and web had no relevant information. Then again, I am very much behind to get this order.
Thank you in advance.
However, I have a massive order tonight and the machine begins engraving, but after a few passes stops in about five inches from the right side. After some examination all I can figure is the air assist line (which is not hooked up to a pump) is kinking as it is being pushed to the right, this pressure is causing enough resistance to make the 'X/Y disabled X' message.
My question is can anyone provide insight in how to fix this? A quick look through the forum and web had no relevant information. Then again, I am very much behind to get this order.
Thank you in advance.