Mike Nguyen
03-13-2015, 1:02 AM
Hi,
I just finished upgrading my Delta 50-760 dust collector with the molded version of Oneida super dust deputy and want to share with everyone who would like to do the same if they have the same dust collector so they don't have to go through researching what to get to make it fits together.
I bought the super dust deputy, the 17 metal drum, and the 6 to 5 inch metal reducer from Woodcraft since they have the 10% off everything couple of weeks ago. The 5 inch hose is from Amazon. It's 10 feet long and cost $52. The hose clamps is from Home Depot and cost $1.89 each. I used 1" conduit from Home Depot cutting 36" long to raise it up so I can have about 4 inches between the top of the super dust deputy and the bottom of the inlet of the dust collector.
http://www.woodcraft.com/Product/159881/ONEIDA-AIR-SYSTEMS-6-Inch-to-5-Inch-Metal-Reducer-Dust-Collection-Fitting.aspx
http://www.amazon.com/Woodstock-W1035-5-Inch-10-Foot-Wire/dp/B0000DD1KI/ref=pd_cp_hi_0
http://www.homedepot.com/p/Everbilt-5-in-Stainless-Steel-Clamp-6772595/202309382
The 5 inch hose fits very tight on the metal reducer. It took me 20 minutes just to put in on the reducer. However, the hose fits nicely and easily over the inlet ports of both the dust collector and the super dust deputy.
I am very happy with the suction. I think it's much stronger than my old set up the the baffle and the trash can. Maybe because I am using 5" hose instead of 4" with the old set up. I will still need to add a 4 inch reducer at the table saw for now.
Thanks for looking.
Mike
309013309012309011
I just finished upgrading my Delta 50-760 dust collector with the molded version of Oneida super dust deputy and want to share with everyone who would like to do the same if they have the same dust collector so they don't have to go through researching what to get to make it fits together.
I bought the super dust deputy, the 17 metal drum, and the 6 to 5 inch metal reducer from Woodcraft since they have the 10% off everything couple of weeks ago. The 5 inch hose is from Amazon. It's 10 feet long and cost $52. The hose clamps is from Home Depot and cost $1.89 each. I used 1" conduit from Home Depot cutting 36" long to raise it up so I can have about 4 inches between the top of the super dust deputy and the bottom of the inlet of the dust collector.
http://www.woodcraft.com/Product/159881/ONEIDA-AIR-SYSTEMS-6-Inch-to-5-Inch-Metal-Reducer-Dust-Collection-Fitting.aspx
http://www.amazon.com/Woodstock-W1035-5-Inch-10-Foot-Wire/dp/B0000DD1KI/ref=pd_cp_hi_0
http://www.homedepot.com/p/Everbilt-5-in-Stainless-Steel-Clamp-6772595/202309382
The 5 inch hose fits very tight on the metal reducer. It took me 20 minutes just to put in on the reducer. However, the hose fits nicely and easily over the inlet ports of both the dust collector and the super dust deputy.
I am very happy with the suction. I think it's much stronger than my old set up the the baffle and the trash can. Maybe because I am using 5" hose instead of 4" with the old set up. I will still need to add a 4 inch reducer at the table saw for now.
Thanks for looking.
Mike
309013309012309011