Sharing Trotec between two PCs.

[Dan Kozakewycz]

I have a member of staff starting with me this week, I need to get his PC linked up to my Speedy100 but also be able to operate the laser from my own PC too. It's probably a really easy thing to set up but I'm IT illiterate, can anyone explain the best way to do this without constantly swapping the USB lead?

[Graham Taylor]

Can you set them both to be on the same network and then share everything and you may be able to send instructions to the laser from both even though the s/w is only on one - not 100% sure though

[Scott Shepherd]

Dan, someone posted that info a while back, sharing the job folder, etc. over a network. I think he explained how he had it all setup, but I don't recall who it was that did it. Search for Trotec and see if you can find it, I know it's here and it's fairly recent (last 3 months or so).

[Scott Shepherd]

Found it here :

http://www.sawmillcreek.org/showthread.php?224068-Sharing-Trotec-Job-Control-spool-folder-Can-do

Tony might be able to point you in the right direction.